Return to menu

Fornax 2S / Scorpius 2S pairing guide

This tutorial is intended for the Fornax 2S remote control in combination with the Scorpius 2S receiver.

Read the instruction View video instruction

Programming a new/additional Fornax 2S transmitter to the Scorpius 2S receiver

Please note: All systems are already programmed at the factory.

If you wish to program a new or extra transmitter to the Scorpius 2S receiver, please follow the steps shown below:

  1. Make sure that the receiver is correctly connected and has supply voltage.
  2. Press the black programming button on the bottom of the receiver for 8 seconds, until the status red LED on the receiver will switch off. This will delete a previously programmed transmitter.
  3. Hold down (keep pressed) the OFF switch on the transmitter and pull the stop button up. Wait until the yellow LED on the transmitter switches off. Only then release the OFF switch. This will delete a previously programmed receiver.
  4. Press the black programming button on the bottom of the receiver for 1 second, the status LED on the receiver will light up red to get into pairing mode.
  5. Keep the OFF switch on the transmitter pressed and pull the stop button up. The yellow LED on the transmitter will light up. Now release the OFF switch.
  6. After a few seconds, the yellow LED on the transmitter and the red LED on the receiver will switch off. The transmitter and the receiver are now programmed to each other.

Instruction video Fornax 2S / Scorpius 2S

Updated video for the Scorpius 2S receiver coming soon.
This video shows the Aquarius receiver, but the intructions are very similar.
Also please read the written instruction.


Any questions? Please contact us

Do you still have any questions or problems about pairing your transmitter? We will be pleased to assist you, please give us a call: +31(0)546 588 790 or submit our contactform.