Return to menu

Indus / Gemini pairing guide

This tutorial is intended for the Indus 1S remote control in combination with the Gemini receiver.

Read the instruction View video instruction

Programming a new/additional Indus transmitter to the Gemini receiver

Please note: All systems are already programmed at the factory.

If you wish to program a new transmitter to the Gemini receiver, please follow the steps shown below:

  1. Make sure that both the transmitter is switched off.
  2. Unscrew the casing of the receiver. You will see 2 PCBs on top of each other.
  3. Make sure that the receiver is correctly connected.
    1. Connect the power supply to the V+ screw terminal of the receiver.
    2. Connect the ground cable to the V- screw terminal of the receiver.
  4. Switch on the supply voltage. 
  5. Activate the programming mode by pushing the white button on the bottom receiver PCB.
  6. The status LED on the receiver lights up red, you can now release the white button.
  7. Activate the transmitter within 20 seconds, after 20 seconds the program mode will be discontinued. To pair start up the receiver again.
  8. Once the transmitter is enabled within 20 seconds the LED on the receiver will start flashing yellow.

Note:
Only 1 transmitter can be programmed on the Gemini 1S as soon as a new transmitter is programmed, the previously programmed transmitter will be overwritten.

Instruction video Indus / Gemini

Any questions? Please contact us

Do you still have any questions or problems about pairing your transmitter? We will be pleased to assist you, please give us a call: +31(0)546 588 790 or submit our contactform.